ENDAT-GX201 USER’S MANUAL
UNICORN COMPUTER CORP.
37
˙
Resolution
This field is used to select the resolution of LCD panel.
<Choice: 640x480/800x600/1024x768/1152x864/1280x1024/1600x1200>
˙Bus Width
This field is used to select the bus width of LCD panel. Generally is “24bits”.
<Choice: 8/9/12/16/18/24>
˙
Data type
This field is used to select the data type of LCD panel. Generally is “Normal”.
<Choice: Normal/2 X>
˙
Refresh Rate
This field is used to select the refresh rate (VSYNC frequency) to LCD panel.
Default is “60 Hz”.
<Choice: 60/65/70/72/75/85>
˙
HSYNC Polarity
This field is used to select the polarity of HSYNC for LCD. Default is “Low”.
<Choice: Low/High>
˙
VSYNC Polarity Active
This field is used to select the polarity of VSYNC for LCD. Default is “Low”.
<Choice: Low/High>
˙
SHFCLK Active Period
This field is used to select the working period of shift clock. Generally is “Free
running”.
<Choice: Free running/Active only>
˙
LP Active Period
This field is used to select the working period of line pulse. Generally is “Normal”.
<Choice: Free running/Active only>
If you apply one of the standard panels shown above, select the appropriate
option according to the type of panel that you apply. Or, please contact your
dealer or sales representative for custom-made BIOS that will suit the panel that
you apply.
ENDAT-GX201 USER’S MANUAL
UNICORN COMPUTER CORP.
38
3-4. Integrated Peripherals
The IDE hard drive controllers support up to two separate hard drives. These drives
have a master/slave relationship that is determined by the cabling configuration
used to attach them to the controller. Your system supports two IDE controllers--a
primary and a secondary--so you can install up to four separate hard disks.
Integrated Peripherals
Item
Optimized defaults
Master Drive PIO Mode
Auto
Slave Drive PIO Mode
Auto
IDE Primary Master UDMA
Auto
IDE Primary Slave UDMA
Auto
IDE DMA transfer access
Enabled
IT8888 ISA Decode IO
Press Enter
IT8888 ISA Decode Memory
Press Enter
IT8888 DDMA
Press Enter
IDE HDD Block Mode
Enabled
Onboard Lan Boot ROM
Disabled
Onboard FDC Controller:
Enabled
Onboard Serial Port 1
3F8/IRQ4
Onboard Serial Port 2
2F8/IRQ3
Onboard Serial Port 3
3E8/IRQ4
Onboard Serial Port 4
2E8/IRQ3
Onboard Parallel Port
378/IRQ5
Parallel Port Mode
Standard
ECP Mode Use DMA
3
˙
Master/Slave PIO Mode
The two IDE PIO (programmed Input/Output) fields let you set a PIO mode (0-4)
for each IDE device that the internal PCI IDE interface supports. Modes 0
through 4 provide successively increased performance. In Auto mode, the
system automatically determines the best mode for each device.
˙
IDE Primary Master/Slave UDMA
These fields allow you to set the Ultra DMA in use. When Auto is selected, the
BIOS will select the best available option after checking your hard drive or
CD-ROM.
