Unicorn series User Manual
23
PS/2 ports on the rear panel of your computer. Or you can use USB interface to
connect your computer. ( Use PS/2-USB switch to select your interface. The
switch has to be on PS/2 side when you use PS/2 interface connector.)
4. Use USB A-A cable connect USB HUB port and USB port of system.
5. Connect the AC to DC power adapter to the power inlet on the console and then to
a power outlet.
3.5 Fingerprint Scanner
Please install the driver from website or folder “Driver” in CD.
Figure 3-3. Fingerprint Scanner
3.6 Turning on the Console
Make sure all cables and the AC to DC power adapter are connected properly. Be
sure to tighten all connector screws. Grab the front handle. Pull the console all the
way out then lift the panel up. This will disengage the momentary on/off switch and
the unit should power on. The LCD on the left or underneath of the panel will be green
light.
3.7 Testing the Console
To test that the console is working properly, perform the following steps:
Fingerprint Scanner
