5686G-PRO User Guide
Page
26
of
94
Copyright © 2018 USR, a Division of UNICOM Global
What The Guest User Needs To Do
When guest users want to call in to the host (assuming you have enabled Dial Security by
entering ATS53.0=1),
They must know the password.
If you have enabled Dialback, they must set their device to auto -answer.
1.
If the host has security enabled, get a password from the host’s administrator. The password is
case-sensitive, so be sure to copy it correctly.
If the host has prompting enabled and the host operator enables Dialback for your account, skip
to Step 3.
2.
For guest users with Courier Lite 56K Business Modems (or I-Modems) only:
a)
Create a security account using the password the host’s administrator asked you to use. (See
, earlier in this section for instructions.)
b)
You need to assign the password as your Autopass password.
For your modem to
Command
Assign the password as your Autopass password.
AT%V=PW
n
where
n
is the number of the
account you set up.
Example:
Sending
AT%V=PW3
will assign the password as an Autopass password for account 3.
c)
Check to see that you set your Autopass password correctly by using the
ATI10
command.
Your Autopass password appears beside AUTOPASS PASSWORD if you have done all the steps
correctly.
d)
Once the Autopass password is set, enable your Courier Lite 56K Business Modem’s Dial
Security.
For your modem to
Command
Enable Dial Security
ATS53.0=1
CAUTION:
If you do not follow an S-Register setting with &W, the setting will be retained only
until the next reset or power off.
