5686G-PRO User Guide
Page
14
of
94
Copyright © 2018 USR, a Division of UNICOM Global
Other Remote-Access Commands
The table below is a list of remote-access configuration commands.
For your modem to
Command
Display a view-only password
AT%P0?
Display a view-and-change password
AT%P1?
Erase a view-only password
AT%P0=
Erase a view-and-change password
AT%P1=
Disable remote access entirely
ATS41=0
Example:
Sending
AT%P1=
will erase the view and change password.
WARNING:
If you erase the
%P1
password without disabling remote access (using
ATS41=0
), anyone
could access the Courier Lite 56K Business Modem and change its configuration.
Accessing The Host at the Guest Device
The guest device requires no configuration to access the host. Follow these steps:
1.
Be sure that the host device has enabled remote access and is set to auto -answer (ATS0=1).
Know the password, if you will need one.
2.
Call the host device (although it doesn’t matter which device originates the call).
3.
After a connection is established, do this:
Pause 4 seconds.
Type 4 tildes:
~~~~
Pause 4 seconds.
Note:
The administrator of the host device can change the remote -access character using S-
Register 42, and the pause duration using S-Register 43. Refer to the
section for
more information.
