Wire Colour
Function
Connect To
Red
Black
Yellow
Blue
Power
Ground
Pattern Selection
Synchronization
+12/24 VDC (Power)
-
12/24 VDC (Ground)
- 12/24 VDC (Power)
Synchronization Wire from another Unit
1.0
Pattern Selection
Tap Yellow wire to Ground (Black wire) momentarily
1.1
Flash Patterns
2.0
Synchronizing
All lights must be set to the same Flash Pattern before connecting
synchronization (Blue) wires
ON - OFF Switches
can be used for Power (Red wire)
OFF - (Momentary)ON Switches
can be used for pattern selection (Yellow wire)
- All lights are set to secondary by default at factory.
- One light in each group can be selected as the
primary lamp
and control the pattern
change in all lights of the group.
- To setup primary unit, connect the
Pattern Selection (Yellow wire)
to
Ground (Black wire)
for 5 seconds. The light will turn off and turn on again.
2.1
Switches to Use
NOTE: Only E-7315 & E-736 & E-735 can be synchronized
INSTALLATION MANUAL
E-735AB & E-735AW
All lights must be set to the same Flash Pattern before synchronizing
NO.
Pattern
NO.
Pattern
SAE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Quad, Alternating
Double, Alternating
Triple, Alternating
Quad, Alternating
Double, Alternating Left/Right
Triple, Alternating Left/Right
Quad, Alternating Left/Right
Single, Amber
Triple, Amber
Quad, Amber
Quad, Amber
Pulse, Amber
Single, Blue or White
Triple, Blue or White
Quad, Blue or White
Quad, Blue or White
Pulse, Blue or White
SAE
SAE
SAE
SAE
Dual
Colour
Single
Colour
(Amber)
Single
Colour
(Blue
or
White)
