Uneek 4x4 GU-RB-ASM5, Инструкция по монтажу

Страница: 9 / 20

Remove factory bumper and spare tyre
including factory tyre carrier.
First thing to do is to fit both indicator lights
to the bar with shown indicator bracket. To
get access behind the lights you need to pry
out the lens with a screwdriver and this
allows access to the screws. Once the wires
have been fed through the bracket using m5
hardware, fit to the bumper.
Series 4 and later vehicles will require the
center tow point protrusion to be cut off.
Remove the entire protruding sheet metal
section and grind back the welds then cover
with paint.
If fitting the rear stainless step (instead of
rear winch mount) you will need to use the
“ step tie in brackets ” . “ Step tie in brackets ”
are to be loosely fastened onto the bar with
secondary hole facing outward from the
centre of the vehicle, M8 Button head cap
screw and M8 nyloc nut.
Secondary holes
facing outwards