18
OPERATION
OPERATION
TO SET TRAVEL LIMITS:
1.
Use the DP1U controller “Up” and “Down” buttons to drive the lifter to the desired
up limit
position.
2.
Once the desired
up limit
travel has been reached press “S” then “1” within two seconds. This saves
the
up limit
to the lift controller. Holding “1” should now drive the lift to the saved up limit.
3.
Use the DP1U controller “Up” and “Down” buttons to drive the lifter to the desired
down limit
position.
4.
Once the desired
down limit
travel has been reached press “S” then “2” within two seconds. This
saves the down limit to the lift controller. Holding “2” should now drive the lift to the saved down limit.
5.
The infrared remote will now control the lift between the set limits.
LEARNING A NEW REMOTE:
To learn a new remote handset, point the remote at the IR receiver then press and hold the stop “
-
“ button
for 10 seconds.
DP1U
Infrared Remote
Ultralift UIRC
IMPORTANT
The lift should not be run up and down more than 4 times, or continuously at full load for
more than 1 minute without a 10-minute break.
Overheating will damage the Control Box.
