12
Procedure 3
Procedure 4
Procedure 5
The shaft should be in the center of the cowling hole.
1.5mm
Using tape to temporarily hold the cowling in place, install
the spinner/prop assembly onto the motor output shaft
by tightening the two hex screws on each side of the
prop adaptor. Make sure these two screws are tight
and secured as if they are not, the prop may come free
from the motor and hurt either yourself or others around
you.
Prop adapter
M3x3
1.
2.
1.Assembly the spinner as shown in the graphics.
Use a hand drill to drill the screw hole at the
screw mount location. Finally fasten it up with
the M2x5 screw and remove the tape.
