ALARM MODELS ONLY
NOTE- If the system has been triggered (shock sensor, door input..), the siren will sound for approximately
60 seconds. Press and release the lock or unlock button to silence the siren (the system will remain armed).
Press the unlock button to disarm the system. The siren and park lights will flash three times to indicate the
system had been triggered.
SYSTEM PROGRAMMING -
Menu 1
PAGE 26
95 SERIES
INSTALL MANUAL
SHOCK SENSOR SETTINGS
PRESS AND RELEASE THE UNLOCK BUTTON TO
DECREASE THE SENSITIVITY. THE LCD WILL SHOW
THE CURRENT SETTING. THE LOWEST (LEAST
SENSITIVE SETTING IS SEN 1.
THE SHOCK SENSOR SENSITIVITY IS SET USING THE REMOTE PROGRAM MODE
FEATURE. ALARM MODELS ONLY.
PRESS AND RELEASE THE START BUTTON TO
INCREASE THE SENSITIVITY. THE LCD WILL SHOW
THE CURRENT SETTING. THE HIGHEST (MOST
SENSITIVE) SETTING IS SEN 10.
PRESS AND RELEASE THE STATUS BUTTON ON THE REMOTE TO EXIT.
ENTER REMOTE PROGRAM MODE
ADJUSTING THE SENSOR SENSITIVITY
EXIT PROGRAM MODE
UL
TRA
UL
TRA
UL
TRA
SEN 3
OFF
SEN 7
SEN 5
OFF
OFF
1
1
1
UL
TRA
M-1234
PROGRAM
TO ENTER PROGRAM MODE
PRESS AND HOLD THE STATUS BUTTON ON THE
REMOTE FOR 4 SECONDS.
THE REMOTE WILL BEEP 1 TIME AND THEN 3 TIMES.
THE DISPLAY WILL SHOW “PROGRAM” & “M-1234"
ENTER SHOCK SENSITIVITY PROGRAMMING
PRESS AND RELEASE THE UNLOCK BUTTON
THE SENS LEVEL WILL BE DISPLAYED
SYSTEM PROGRAMMING -
Menu 1
PAGE 27
95 SERIES
INSTALL MANUAL
QUICK VIEW OPERATIONS
SYSTEM PROGRAMMING -
Menu 1
QUICK VIEW OPERATION CHART
1 SECOND
3 SECONDS
1 SECOND (PANIC OR ALARM)
1
1
OFF
LOCK / ARM ALARM
ACTIVATE PANIC
ALARM/ PANIC OFF
1 SECOND
1 SECOND (PANIC OR ALARM)
HOLD FOR 3 SECONDS
2
OFF
2 + 1
UNLOCK / DISARM
ALARM/ PANIC OFF
1 SECOND
1 SECOND WHEN RUNNING
3 SECONDS W/ REMOTE START
1
1
2
REMOTE START
EXTENDED RUNTIME
SHUTDOWN
HOLD FOR 3 SECONDS
2
1
TRUNK RELEASE
BUTTON
LENGTH OF PRESS
CHIRPS /
FLASHES
SYSTEM OPERATION
SERVICE MODE / EMERGENCY OVERRIDE
TO AVOID SERIOUS INJURY, this remote start system must be set into Service Mode
before any under hood servicing is started. Service Mode will prevent the vehicle from
starting while the vehicle is being serviced. It is the sole responsibility of the vehicle’s
owner to place the system into Service Mode. The manufacture accepts no
responsibility for accidental starting of the vehicle while the vehicle is being serviced.
ACTIVATING / DEACTIVATING VALET MODE / EMERGENCY OVERRIDE
Turn the Ignition Key ON
(Leaving the key ON)
Press and hold the Valet switch for 8 to 15 seconds
(Time depends on "Valet Settings" Program Option)
REMOTE START AND ALARM DEACTIVATED
REMOTE START AND ALARM ACTIVATED
5 CHIRPS = OFF
2 CHIRPS = ON
HOLD FOR 3 SECONDS
PRESS AND RELEASE
5 LONG
STATUS
STATUS CHECK ON 2WAY
