US-5000C
US-5000C Rope Grabs are made of durable non-corrosive
stainless steel, brass & bronze. They are 100% inspected for
function, construction and material integrity and are designed to
meet the performance requirements of ANSI Z359.1, OSHA 1926
(maximum 6 ft or 1.8m) when used with Polysteel / Poly Pro Blend
lanyard be positioned not to exceed 6’ free fall. The 5/8" (16mm)
Rope must be installed and maintained properly (see LIFELINES
below).
NOTE: This Rope Grab is intended to be used as part of a complete
personal fall protection system. All other components subsystems
and connectors used in conjunction or attached to this Rope Grab
should be compatible and meet the appropriate OSHA /ANSI /CSA
requirements for the intended application. Substandard or non-
approved components could compromise the reliability of the
system and jeopardize safety of the user.
BEFORE EACH USE:
• Open unit and inspect. All components must be free of dirt
or debris.
(Also see LIFELINE INSPECTION below)
• Check components for damage or wear that may affect the
free movement and/or operation of the mechanism. If in
doubt of condition do not use. Units with signs of any of the
following check items should be removed from service and
properly discarded.
• The upper tension roller should rotate and move freely in its
slot under spring tension
• Inspect gripping mechanism for proper operation by
pivoting ring and gripper back and and forth. Movement
should be free easy without binding. The spring resistance
should be noticeable.
• The locking screw should thread easily and tighten against
the body with body parts touching
• The locking clip should rotate easily and pass over the detent
and into the notch of the body with sufficient resistance to
hold it in the locked position.
• Do not attempt to alter or repair this Rope Grab.
• All other components of the fall protection system attached
to and used in conjunction with this Rope Grab should be
inspected as per manufacturers instructions and OSHA
/ANSI /CSA guidelines.
• Record inspection results and keep on file.
Equipment users must be fully trained in and conversant with all regulatory requirements applicable to the workplace, in
which the fall protection equipment is to be used. If in doubt contact your local OSHA or CSA office for clarification. Such
training should include information about local circumstances, rules and regulations applicable to the work situation, a
hands-on opportunity to learn how to wear and attach equipment properly, instructions about
DROP LINE & LIFE LINE:
type & selection, strength, stretch, wear, degradation factors, use & maintenance.
HARNESS:
type & selection, use & maintenance.
LANYARD, SAFETY SNAPS AND HARDWARE:
type & selection, compatibility, use & maintenance.
ANCHOR POINTS:
proper techniques and hardware for securing and connecting lanyards, drop lines or lifelines.
PHYSICS OF FALLING:
calculating falling distance, hazards, assessing total fall arrest system.
OWNERS MANUAL
MODEL:
US-5000C
DESCRIPTION:
Rope Grab 5/8”
MEETS OSHA & ANSI Z359.1
1-800-850-5914
PHOENIX, ARIZONA USA
WWW.ULTRASAFEUSA.COM
THESE INSTRUCTIONS FOCUS ON THE CARE AND USE OF THIS ROPE GRAB AND ARE NOT
A SUBSTITUTE FOR A FORMAL CLIMBING AND FALL PROTECTION TRAINING PROGRAM.
1
313RG1
