![background image](http://html1.mh-extra.com/html/uls/vls-series/vls-series_service-manual_3339352073.webp)
VLS Service Manual - REV2015.04
Electronics
Page | 73
Electronics
7. Remove the Power Supply Module by carefully lifting up from the Rear Shelf, making sure no cables are
pinched in the process.
8. Installation is opposite of removal.
Power Supply Module
1. Power OFF and unplug the VLS system.
2. On the back of the system, unscrew the 4 Button Head Screws located underneath the right Rear Shelf.
Set the screws and washers aside.
3. After removing the 4 Button Head Screws, proceed to the left side of the VLS. Located near the power
inlet is a small button head screw. Remove the screw and set it aside.
4. Open the rear cover to its resting position.
5. Remove the laser and set it aside in a safe place.
6. The Power Supply connectors are located between the Power Supply Module and CPU Module.
Disconnect the 2 large white connectors and the small black connector.
Содержание VLS Series
Страница 1: ...VLS Service Manual...