7. WiFi Function
09
1. Choose to pole mount or wall-mounted, adjust the CPE orientation, the
bracket is not included in the package. Recommended ULNA Universal
Bracket (ASIN: B0B5TWYHWC).
2. Prepare a long enough network cable to connect the PoE adapter and CPE,
the network cable is connected to the LAN port of the CPE, and the other
end is connected to the PoE port of the PoE adapter. Recommend to use a
cat 5 (or above) shielded network cable with a ground wire.
3. Connect the PoE adapter PoE to CPE, and LAN to Camera, PC, Router or
Switch based on the network topology. The role of PoE is to provide power
and data transmission for CPE.
4. The master CPE’s PoE adapter’s LAN connection monitors the Internet, and
the slave CPE’s PoE adapter LAN connects cameras or routers and other
equipment.
Note:
For point-to-point installation, the line of sight of the 2 wireless bridge brackets
must be clear and cannot pass through the wall. The signal transmission angle
of the bridge is 60 degrees. For point-to-multipoint installation, the angle of the
slave bridge needs to be adjusted to ensure that it is within the 60-degree
signal range of the main bridge. The antenna polarization direction is horizontal
60°/vertical 30°.
1. The WiFi function is turned on by default for the master bridge. The slave
bridge is unable to provide WiFi, it is recommended to connect a new router.
WiFi SSID: CPE5G-5GXXX
WiFi PWD: zllinkcpe123456XXX
XXX represents different channels, please refer to the comparison table in
the user manual.
2. You can access the wireless bridge through your computer to set the SSID
and new WiFi password. Please refer to the advanced settings section.
