1
2
Quick Install Guide
USB
USB
LAN
WAN
DC IN 12V
SET
WPS
AWAY
STAY
USB
USB
LAN
WAN
DC IN 12V
SET
WPS
SET button
SET button
Gateway
Panel Console
CO
2
Contact Sensor and other devices
Power Switch
AWAY
STAY
SET/Reset Reboot
SET button
SET
SET button
SET
ALARM
CO
2
Monitor
push and hold “▲” & “▼”
together until the screen blinks
Connect to
NGW-240…
Power On
Device Joining
Gateway
2.1 Gateway vs ALL RF devices
1. Short press the
SET
button at the back of the Gateway. Wait until the Alarm LED blinks red before releasing
the
SET
button.
2. Short press the
SET
button at the back of the device until the LED blinks green.
3. Wait for few seconds until both LEDs (on the Gateway and device) turned off. This indicates the binding
process is successful.
2.2 Router(Power Switch) vs ALL RF devices
1. Short press the
SET
button on the Power Switch until the LED blinks green.
2. Short press the
SET
button at the back of the device until the LED blinks green.
For CO
2
sensor, press both the
and
buttons until the screen blinks.
3. Wait for few seconds until both LEDs (on the Router and device) turned off. This indicates the binding
process is successful.
Note:
• RF devices are including Sensor, Console, Switch, and Transducer.
Panel Console
Contact Sensor
Plug in the power adapter or insert the battery.
