7/21/2014
Specialized Business Solutions
Page 1
UIC PP795 PIN Pad with Signature Capture
Installation overview for the UIC PP795 Pin Pad Device with Signature Capture
In order for the Keystroke POS to use the UIC Signature Capture/PIN Pad, it requires the device to be recognized as a
Serial Device. If using a USB cable, you will need to run the PP790 USB Driver Setup Wizard (see below).
Hardware: UIC PP795 SIGNATURE CAPTURE/PIN PAD device
USB Driver: On the Keystroke POS CD (only needed if using a USB cable)
Keystroke Payment Server: KeyPay.exe ("Install Other Software" on the CD)
Keystroke Software: Keystroke POS - v7.00 Build 56 or later.
Connecting the Device to the Computer
-
The UIC PP795 device can be connected to the computer with either a RS232 Serial cable or using a USB Cable
-
If using a serial cable, hook up the device at this time and connect it to a serial port, then skip the USB Setup
below
-
If using a USB Cable, download the
UIC_PP795Driver.zip
file from the Keystroke POS website
(
www.keystrokepos.com
). Unzip this file in your \KEYSTROK program directory. You will find the required driver
files in the \KEYSTROK\DRIVERS\UIC\PP795\ folder
Installing the USB driver
-
If you are connecting the device using a USB Cable, you must install the USB drivers first
-
Open the "\KEYSTROK\DRIVERS\UIC\PP795 folder
-
As Administrator, run the
PP795_USB_Driver.msi
program and accept the defaults
-
The application may not return a Finished Prompt so give it some time
-
You can now plug the USB device in.
Identifying the COM Port used in Device Manager
-
After plugging in the UIC PP795 PIN Pad device in, a COM port will be assigned by Windows
-
If there are any questions as to what COM port has been assigned, you can go to Device Manager (Right-Click on
My Computer and Select Properties (on XP, click the Hardware Tab)) OR you can open Control Panel, and select
System
-
In Device Manager, look under Ports (COM & LPT). You should see the device listed
-
Make note of the COM port being used (i.e. COM4:).
Setup the PIN Pad hardware in Keystroke POS
-
In Configuration Manager, under Hardware - PIN Pad, select UIC-PP795
-
Under Port, select the COM port as determined by Device Manager above
-
Select Test Device. Follow the prompts
Setup the Signature Capture hardware in Keystroke POS
-
In Configuration Manager, under Hardware - Signature Capture, under Sig Cap Type, select UIC-PP795
-
Under Port, select the COM port as determined by Device Manager above
-
Select Test Device. Follow the prompts.
Setup an Authorization Method for credit card payments that use the mag-stripe reader
-
In Configuration Manager, under Tables - Authorization Methods, select the KPCREDIT Method
-
Verify the Type is set to Credit Card
-
Leave the other fields blank
-
Usually turn on Verify Address, Verify Zip, CVV2, and Manually Entered Only
-
Ok Amount can be on or off
-
Capture Signature should be ON (for Credit Cards)
-
Under Card Reader, select PIN Pad-Card Swipe only (Credit Cards)
-
Select OK to Save
