FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. Any changes
or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation
between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV
technician for help. To maintain compliance with FCC
’
s RF Exposure guidelines, This equipment
should be installed and operated with minimum distance between 20cm the radiator your body:
Use only the supplied antenna.
9
TROUBLE SHOOTING
1.
Q: Why does not the transmitter’s LED light up when I press the button on it?
A:
The
battery power may be exhausted. Please replace the battery.
2. Q: Why can
’
t the lock be unlocked after pressing the transmitter?
A: Please check the issue by the following steps:
a: Check whether the remote control receiver and transmitter are paired successfully.
b:
Check whether there is any metal object around the remote control receiver as it may shield
the signal.
3. Q:
Can
I connect the access keypad to this remote control switch?
A
: Y
es
.