uhlmann & zacher CX8936, Инструкции по эксплуатации и монтажу

Страница: 13 / 18

CX8936 C
OMMISSIONING AND OPERATION
12
5 Commissioning and operation
5.1 Connecting locking units
To connect a locking unit with the online module, you have to perform the follow-
ing steps:

Bring the locking unit which you want to connect into the service mode by
holding the service key in front of the locking unit.
 Use a screwdriver or a similar tool to turn the rotary switch (6) so that the
arrowhead points to Position 8. Then briefly press the button (7) to switch to
the pairing mode and teach in the locking unit within reach.
6) Rotary switch
7) Button
8) LEDs
If successful, the green LED lights up several times and the lock leaves the service
mode directly. If not successful, the red LED lights up several times and the lock
remains in the service mode.
The yellow LED flashes additionally to confirm the button input. The blue LED
flashes to signal the BLE activity.

Turn the rotary switch back to the home position.
Rotary switch position Function
0
Home position
For Wiegand: Sends a test sequence via Pins 4 and 5
when the button (7) is pressed.
4 Briefly press the button (7) to set the online module into
the service mode.
8 Briefly press the button (7) to perform the pairing of the
online module with the locking unit that is in reach and
in service mode or to delete an existing paired locking
unit.
9 Briefly press the button (7) to delete all the saved locking
units and parameters.
Any If you keep the button (7) pressed longer than 4 s and
then release it, the online module switches to the service
mode (as at Position 4).