Ugur UMD 1450 D DF IZMIR, Руководство пользователя

Страница: 18 / 32

User Manual
l
– General Store Type Freezers and Fridges | User Manual – General Store Type Freezers and Fridges
18
EN
Keys;
1- Short press, acknowledge alarms
or see control status. Long press, setup
menu.
2- Press, change temperature set point
3- Short press, see defrost sensor
temperature. Long press, start a defrost
cycle.
4.3.2–SET TEMPERATURE
•Push the middle button until the
temperature value is shown.
•Push the upper or the lower button
and select the new value.
•Push the middle button again to
conclude the setting.
4.3.3–MANUAL DEFROST
Reading the temperature at defrost
sensor.
•Push short the lower button.
Manuel start or stop of a defrost.
• Push the lower button for four
seconds.
4.3.4–CUTOUT ALARM RELAY/
RECEIPT ALARM/SEE ALARM
CODE
•Push short the upper button.
If there are several alarm codes they
are found in a rolling stack. Push the
uppermost or lowermost button to scan
the rolling stack.
4.4 – THERMOSTAT
ADJUSTMENTS
4.4.1–GENERAL INFORMATION
AND INSTRUCTIONS
The explanations regarding the sybols
on the thermostat and general informtion
about the settings are given below.
Thermostat visual is presented on
Image
H4 H4
.
1) [ ] : Parameter Key
2) [ ] : Up Key
3) [ ] : Down Key
4) [
] Status LED: Defrosting
5) [ ] Status LED: Cooling
6) [ ] Status LED: Fan
7) [ ] : Display
8) [ ] LED: Settings mode enabled
9) [ ] LED: Expert settings
4.4.2–SET TEMPERATURE
Push the 3 buttons[ ]Press[ ]
key for 5 seconds. The "Settings mode
enabled" LED flashes. Push [ ]. Push the
2 buttons [
or ]. The display show
must be ^P2^. Then set you want opera-
ting temperature value with only button
[ / ]. Again push [ ].
4.4.3–MANUAL DEFROST
Push the 3 buttons[ ]Press[ ]
key for 5 seconds. The "Settings mode
enabled" LED flashes. Push [ ]. Push
the 2 buttons [
or ]. The display
show must be ^P9^. Then set ‘ON’ only
button[ / ]. When defrost is over, the
device will automatically return to nor-
mal operation.