Ugur UMD 1450 D DF IZMIR, Руководство пользователя

Страница: 10 / 32

User Manual
l
– General Store Type Freezers and Fridges | User Manual – General Store Type Freezers and Fridges
10
EN
3 – INSTALLATION
3.1 – SELECTION OF DEVICE
PLACE
The working environment is very
significant in order for the device
to work smoothly. Ensure that the
conditions stated below are provided
with regards to the place the device
will be installed in for the cooling
performance and energy consumption
to stay within the proper values.
•A bowless, flat and solid ground
shall be chosen for the device.
•The size of the room where the
equipment will be used must be 1 m
3
for each 8g of refrigerant. The amount
of refrigerant that your equipment
contains is written on the label on
the buttom left part back of cabin
(Image J J ).
•The ventilating slits of the
device shall not be covered. There shall
be at least 150 mm distance between the
device’s ventilating slits and the wall.
•There shall be a grounded and solid
plug present close to the device.
•Device shall be placed at least 1
meter away from heat sources (oven,
cooker, stove, radiator etc.)
•Device shall be placed where there
is no direct sunlight.
•Device shall be placed away from
places where there is air stream (against
the air condition openings, under fans,
at doorsteps or close to windows etc.).
SUGGESTION
Comply with the Authorized
Persons guidance and
suggestions for place selection
in order to get the best
performance from the device.
3.2 – TAKING OUT OF PACKAGE
Do not use sharp/piercing
materials to open the package. Take
the device out of the package by
taking the warnings, which are
prepared suitable to all package
materials, stated below into
consideration.
Dismantle the cable ties around
the package and take the cardboard
package off the device. Take out the
styrofoam materials that are at the
top and on the side of the device.
Dismantle the tie, which is under
the device and attached with
pallet, in order to take the device off
the pallet. Get in front of the device
as shown in Image B B push the device
backwards by applying force.