IPU-100P
4.4 DEVICE CONFIGURATION. (Device).
This section allows you to configure the analog parameters and modes of the device.
IPU-100 Mode.
IPU-100P (Normal).
To set the mode of the IPU-100 between 3 options:
The IPU-100 will act as an audio emitter point (VOICE mode) being synchronized with the IP Paging Desk connected to the
AUDIO LINK.
Attention!
Do not use the IPU-100P Mode when no IP Paging Desk is connected to the AUDIO LINK
terminal as it can lock the IPU-100 temporarily until you perform a reboot of the device.
VoIP Codec.
G.711 (u-Law).
G.711 (a-Law).
G.722(ADPCM).
PCM.
Allows selection of the codec to be used to encode both outgoing and incoming calls when the audio source is a microphone.
The options are as follows:
8 bits logarithmic compression and 8KHz sampling frequency. Quality: Low (As Factory Default).
8 bits logarithmic compression and 8KHz sampling frequency. Quality: Low.
8 bits Adaptive Linear Compression and 16KHz sampling frequency. Quality: Medium.
16 bits without compression and 8KHz sampling frequency. Quality: Good.
PCM.
16 bits without compression and 16KHz sampling frequency. Quality: Very Good.
User Manual - IPU-100P
20
610.462A
Rev. 0
4.- DEVICE CONFIGURATION (WEBSERVER)
28
