AeroCut Velocity OPERATION MANUAL
35
5.5.2 If the cut measurement does not match the input value
If the actual size and measurements of output differs from input values, calibrate the
machine via ADJUST screen.
ADJUST screen
Manual speed screen
①
In cases the width of a card or a top margin is different from inputted values,
Input differences between inputted values and actual sizes of outputs into A,B,C and D.
EX:
If the input value is 3.500” and cut measurement is 3.560”, input -0.060.
If the input value is 0.200” and cut measurement is 0.175”, input +0.025.
※：
If you press OK after you input values into A, B, C and D, those values will be added to
each total measurements which are circled on the image below. Then, A, B, C and D will be
reset to 0.000.You can change the measurement by 0.002”.Each adjustment should be
within
±
0.080” at one time. If the gap is more than
±
0.080”, repeat the process until the
desired measurement is reached.
Reset the machine to the factory setting, all the adjusted values
will be 0.
Save the adjusted values and go back to Manual speed Screen
Go back to manual speed Screen without making any changes.
B
A
C
D
Total
measurement
that has been
changed A, B,
C, and D.
