Ublox ZOE-M8 Series, Руководство по интеграции оборудования

Страница: 15 / 34

ZOE-M8 series - Hardware integration manual
UBX-16030136 - R09 Design-in Page 15 of 34
Production information
C9 All GND Ground Ensure good GND connection
D1 All SQI_D0 I/O Data line 0 to external SQI flash memory
or DC/DC configuration pin.
Leave open if not used.
D3 All SQI_CS_N I/O Chip select for external SQI flash memory
or DC/DC enable pin.
Leave open if not used.
D4 All D_SEL I Interface selector See section 2.2
D6 All GND Ground Ensure good GND connection
D9 All GND Ground Ensure good GND connection
E1 All SQI_CLK I/O Clock for external SQI flash memory or
DC/DC configuration pin.
Leave open if not used.
E3 All SQI_D2 I/O Data line 2 to external SQI flash memory
or DC/DC configuration pin.
Leave open if not used.
E7 All GND Ground Ensure good GND connection
E9 All Reserved I/O Reserved Do not connect. Must be left open!
F1 All Reserved I/O Reserved Do not connect. Must be left open!
F3 All SQI_D3 I/O Data line 3 to external SQI flash memory
or DC/DC configuration pin.
Leave open if not used.
F4 All Reserved I/O Reserved Do not connect. Must be left open!
F6 All PIO14 I/O Digital I/O Leave open if not used.
F7 All GND Ground Ensure good GND connection
F9 All Reserved I/O Reserved Do not connect. Must be left open!
G1 ZOE-M8G VCC I Supply voltage Clean and stable supply needed
ZOE-M8Q V_CORE I Core supply voltage Connect to VCC if DCDC not used
G3 All GND Ground Ensure good GND connection
G4 All PIO13 / EXTINT I External interrupt Leave open if not used.
G5 All Reserved I/O Reserved Do not connect. Must be left open!
G6 All GND Ground Ensure good GND connection
G7 All GND Ground Ensure good GND connection
G9 All Reserved I/O Reserved Do not connect. Must be left open!
Only exception is V_BCKP, which can
be connected to this pin if not used.
H1 ZOE-M8G VCC I Supply voltage Clean and stable supply needed
ZOE-M8Q V_DCDC_OUT O DC/DC converter output Connect to VCC if DCDC not used
H9 All V_BCKP I Backup supply
J1 All VCC I Supply voltage Clean and stable supply needed
J2 All VCC I Supply voltage Clean and stable supply needed
J3 All GND Ground Ensure good GND connection
J4 All RXD/SPI MOSI I Serial interface See section 2.2.
J5 All TXD/SPI MISO O Serial interface See section 2.2.
J6 All RESET_N I System reset See section 2.7.
J7 All RTC_I I RTC input Connect to GND if no RTC Crystal
attached.
J8 All RTC_O O RTC output Leave open if no RTC crystal
attached.
J9 All GND Ground Ensure good GND connection
Table 3: Pinout