SARA-R5 series - System integration manual
UBX-19041356 - R04
Approvals
Page 107 of 118
C1-Public
4.3.2
Modifications
ISED Canada requires the user to be notified that any changes or modifications made to this device
that are not expressly approved by u-blox could void the user's authority to operate the equipment.
⚠
Manufacturers of mobile or fixed devices incorporating SARA-R5 series modules are authorized to
use the ISED Canada Certificates of the SARA-R5 series modules for their own final host products
according to the conditions referenced in the certificates.
⚠
Manufacturers of mobile or fixed devices incorporating SARA-R5 series modules are authorized to
use the ISED Certificates of SARA-R5 series modules for their own final host products if, as per
FCC KDB 996369, the antenna trace design implemented on the host PCB is electrically equivalent
to the antenna trace design implemented on the u-blox host PCB used for the regulatory type
approvals of the SARA-R5 series modules, described in details in section
⚠
In case of antenna trace design change, a Class IV Permissive Change application is required to be
filed by the grantee, or the host manufacturer can take responsibility through the ISED Multiple
Listing (new application) procedure followed by an ISED Class IV Permissive Change application.
⚠
If the ISED Certificates of the SARA-R5 series modules can be used for the final host product, as
the conditions above are met, the ISED Label of the module shall be visible from the outside, or the
host device shall bear a second label stating:
"Contains IC: 8595A-UBX19KM01"
⚠
Innovation, Science and Economic Development Canada (ISED) Notices
This Class B digital apparatus complies with Canadian CAN ICES-3(B) / NMB-3(B).
Operation is subject to the following two conditions:
o
this device may not cause interference
o
this device must accept any interference, including interference that may cause undesired
operation of the device
Radio Frequency (RF) Exposure Information
The radiated output power of the u-blox Cellular Module is below the Innovation, Science and
Economic Development Canada (ISED) radio frequency exposure limits. The u-blox Cellular Module
should be used in a manner such that the potential for human contact during normal operation is
minimized.
This device has been evaluated and shown compliant with the IC RF Exposure limits under mobile
exposure conditions (antennas are greater than 20 cm from a person's body).
This device has been certified for use in Canada. Status of the listing in the Industry Canada’s REL
(Radio Equipment List) can be found at the following web address:
http://www.ic.gc.ca/app/sitt/reltel/srch/nwRdSrch.do?lang=eng
Additional Canadian information on RF exposure also can be found at the following web address:
http://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf08792.html
⚠
IMPORTANT: Manufacturers of portable applications incorporating the SARA-R5 series modules
are required to have their final product certified and apply for their own Industry Canada
Certificate related to the specific portable device. This is mandatory to meet the SAR
requirements for portable devices.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
