SARA-G3 and SARA-U2 series - System Integration Manual
UBX-13000995 - R26
System description
Page 76 of 217
1.11
General Purpose Input/Output (GPIO)
SARA-G300 and SARA-G310 modules do not support GPIOs.
SARA-G340, SARA-G350 and SARA-U2 modules provide pins which can be configured as general purpose input
or output, or can be configured to provide special functions via u-blox AT commands (for further details, see the
u-blox AT Commands Manual
[3], +UGPIOC, +UGPIOR, +UGPIOW, +UGPS, +UGPRF):
SARA-G340 and SARA-G350 modules provide 4 configurable GPIO pins:
GPIO1
,
GPIO2
,
GPIO3
,
GPIO4
SARA-U2 modules provide 9 configurable GPIO pins:
GPIO1
,
GPIO2
,
GPIO3
,
GPIO4
,
I2S_RXD
,
I2S_TXD
,
I2S_CLK
,
I2S_WA
,
SIM_DET
GPIO3
pin of SARA-G3 modules product versions “02” onwards can be used additionally for diagnostics.
The following functions are available:
Network status indication
:
The
GPIO1
, or the
GPIO2
,
GPIO3
,
GPIO4
and, on SARA-U2 series only, the
SIM_DET
, alternatively from
their default settings, can be configured to indicate network status (i.e. no service, registered home network,
registered visitor network, voice or data call enabled), setting the parameter <gpio_mode> of AT+UGPIOC
command to 2.
No GPIO pin is by default configured to provide the “Network status indication” function.
The “Network status indication” mode can be provided only on one pin per time: it is not possible to
simultaneously set the same mode on another pin.
The pin configured to provide the “Network status indication” function is set as
o
Continuous Low,
if no service (no network coverage or not registered)
o
Cyclically High for 100 ms, Low for 2 s,
if registered home 2G network
o
Cyclically High for 50 ms, Low for 50 ms, High for 50 ms, Low for 2 s,
if registered home 3G network
o
Cyclically High for 100 ms, Low for 100 ms, High for 100 ms, Low for 2 s,
if registered visitor 2G network (roaming)
o
Cyclically High for 50 ms, Low for 50 ms, High for 50 ms, Low for 100 ms,
if registered visitor 3G network (roaming)
o
Continuous High,
if voice or data 2G/3G call enabled
GSM Tx burst indication
:
GPIO1
pin can be configured by AT+UGPIOC to indicate when a GSM Tx burst/slot occurs, setting the
parameter <gpio_mode> of AT+UGPIOC command to 9.
No GPIO pin is by default configured to provide the “GSM Tx burst indication” function.
The pin configured to provide the “GSM Tx burst indication” function is set as
o
High, since ~10 µs before the start of first Tx slot, until ~5 µs after the end of last Tx slot
o
Low, otherwise
SARA-U280, SARA-U270-73S and SARA-U270-53S modules do not support the “GSM Tx burst
indication” function, as the module does not support 2G radio access technology.