NORA-B1 series - System integration manual
UBX-20027617 - R02
Regulatory information and requirements
Page 48 of 58
C1-Public
6.10
Pre-approved antennas list
This section lists the different external antennas that are pre-approved for use together with the
NORA-B1 series modules.
☞
Note that not all antennas are approved for use in all markets/regions.
6.10.1
Antenna accessories
Name
U.FL to Reverse Polarity SMA adapter cable
Connector
U.FL and Reverse Polarity SMA jack (outer thread and pin)
Impedance
50
Ω
Minimum cable loss
0.5 dB, The cable loss must be above the minimum cable loss to
meet the regulatory requirements. Minimum cable length 100 mm.
Comment
The Reverse Polarity SMA connector can be mounted in a panel. See
Appendix B for information how to integrate the U.FL connector. It
is required to followed this reference design to comply with the
NORA-B1 FCC/IC modular approvals.
Approval
FCC, IC, RED, MIC, NCC, KCC, ANATEL, RCM and ICASA
6.10.2
Single band antennas
NORA-B106
Manufacturer ProAnt
Gain
+2 dBi
Impedance
N/A
Size
Integrated into module
Type
PCB trace
Comment
PCB antenna on NORA-B106. Should not be mounted inside a metal
enclosure.
Approval
FCC, IC, RED, MIC, NCC, KCC, ANATEL, RCM and ICASA
FXP72.07.0053A
Manufacturer Taoglas
Gain
+5 dBi
Impedance
50
Ω
Size
30.4 x 30.9 mm
Type
Patch
Connector
U.FL (UMCC), IPEX MHF1
Comment
Should be attached to a plastic enclosure or part for best performance.
To be connected to a U.FL connector.
See Appendix B for information how to integrate the U.FL connector. It is
required to followed this reference design to comply with the NORA-B1 FCC/IC
modular approvals.
Approval
FCC, IC, RED, MIC, NCC, KCC, ANATEL, RCM and ICASA
