TOBY-L2 and MPCI-L2 series - System Integration Manual
UBX-13004618 - R07
Advance Information
Design-in
Page 111 of 158
2.6.3
DDC (I
2
C) interface
The I
2
C bus compatible Display Data Channel interface is not available on MPCI-L2 series modules.
2.6.3.1
Guidelines for DDC (I
2
C) circuit design
I
2
C bus function is not supported by TOBY-L2 “00”, “01”, and “50” product versions: the pins should not
be driven by any external device.
General considerations
The DDC I
2
C-bus master interface can be used to communicate with u-blox GNSS receivers and other external
I
2
C-bus slaves as an audio codec. Beside the general considerations reported below, see:
the following parts of this section for specific guidelines for the connection to u-blox GNSS receivers
the section 2.7.1 for an application circuit example with an external audio codec I
2
C-bus slave
To be compliant with the I
2
C bus specifications, the module bus interface pads are open drain output and pull up
resistors must be mounted externally. Resistor values must conform to
I
2
C bus specifications
[12]: for example,
4.7 k
resistors can be commonly used. Pull-ups must be connected to a supply voltage of 1.8 V (typical), since
this is the voltage domain of the DDC pins which are not tolerant to higher voltage values (e.g. 3.0 V).
Connect the DDC (I
2
C) pull-ups to the
V_INT
1.8 V supply source, or another 1.8 V supply source enabled
after
V_INT
(e.g., as the GNSS 1.8 V supply present in Figure 62 application circuit), as any external signal
connected to the DDC (I
2
C) interface must not be set high before the switch-on of the
V_INT
supply of
DDC pins, to avoid latch-up of circuits and let a proper boot of the module.
The signal shape is defined by the values of the pull-up resistors and the bus capacitance. Long wires on the bus
will increase the capacitance. If the bus capacitance is increased, use pull-up resistors with nominal resistance
value lower than 4.7 k
, to match the
I
2
C bus specifications
[12] regarding rise and fall times of the signals.
Capacitance and series resistance must be limited on the bus to match the I
2
C specifications (1.0 µs is the
maximum allowed rise time on the
SCL
and
SDA
lines): route connections as short as possible.
If the pins are not used as DDC bus interface, they can be left unconnected.
ESD sensitivity rating of the DDC (I
2
C) pins is 1 kV (Human Body Model according to JESD22-A114).
Higher protection level could be required if the lines are externally accessible and it can be achieved by
mounting an ESD protection (e.g. EPCOS CA05P4S14THSG varistor array) close to accessible points.
