C099-F9P - User guide
UBX-18063024 - R12
Using the C099-F9P
Page 17 of 40
C1-Public
Figure 16: CLI help command
Figure 17: Example RPC syntax
By typing the help command as in Figure 16, the ODIN-W2 will display all available user commands
with a short description. The CLI embodies character echo with limited text edit functions. Misspelled
commands are replied to with a list of supported commands. Note that ODIN-W2 features I/O-related
functions for diagnostic purposes. These functions are listed by the CLI but are not documented in
this User guide.
4.4
Persistent ODIN-W2 settings
By default the ODIN-W2 starts in Bluetooth initiator role, and the ODIN-W2 UART1 is configured to
use a 460800 baud rate. However, some user settings can be stored in the non-volatile data storage
(flash) in the ODIN-W2 and applied after a power cycle.
The user settings are saved into the flash memory via the following CLI command:
/mem_store/run <argument 1> <argument 2>
4.4.1
Revert to factory default
Factory default settings can be set by one of the two methods:
1.
/mem_erase/run
(via CLI)
2.
Press down the SW0 button for more than 3 seconds.
During the next re-start of the ODIN-W2, the factory default settings will be applied.
Содержание C099-F9P-2
