C099-F9P - User guide
UBX-18063024 - R12
Using the C099-F9P
Page 13 of 40
C1-Public
4
Using the C099-F9P
The ZED-F9P is shipped with the latest HPG firmware. Check the latest ODIN-W2 Mbed FW
availability and information on the FW update procedures in section 7 Firmware update.
4.1
Powering the board
The board can be powered from a variety of sources:
•
The USB connection,
•
A 3.7 V Li-Po Battery via a JST connector,
•
An external 6-12 V DC source via a 2.1 mm connector; center pin V+. Also, the included USB-to-DC
plug adapter cable can be used to provide an additional USB power source.
Figure 9: Power connections
Figure 10: Typical single cell 3.7 V Li-Po battery with JST connector
⚠
Follow all published safety advice for using bare cell Li-Po batteries while charging. Protect the
batteries from mechanical damage. Fire risk can occur if the advice is not followed.
⚠
Ensure correct polarity on the JST battery connector. In case of an incorrect polarity, the incorrect
polarity LED will be on. Due to the polarity protection feature, the supply rails will not be powered.
All supply connections are fed via a Schottky diode to the main supply bus to allow multiple sources
to be connected in parallel. The Li-Po battery will be charged from either the DC power source or the
DC power jack
Li-Po battery connector
USB
Содержание C099-F9P-0-03
