Ublox AMY-6M, Руководство по интеграции оборудования

Страница: 45 / 57

AMY-6M - Hardware Integration Manual
UBX-17021971 – R07 Appendix
Page 45 of 57
Appendix
A Migration to u-blox
-
6 receivers
A.1 Migration from AMY-5M to AMY-6M
Pi
n
AMY-5M AMY-6M Remarks for Migration
Pin Name Typical Assignment Pin Name Typical Assignment
A1 RF_IN RF_IN no change
A2 GND GND no change
A3 NC NC no change
A4 GND GND no change
A5 XTAL_OUT Leave open if no
RTC attached. XTAL_OUT Leave open in no
RTC attached.
no change
A6 XTAL_IN GND if no RTC
attached. XTAL_IN GND if no RTC
attached.
no change
A7 VDD_LNA Supply capacitor to
GND. VDD_LNA
Leave open. No need to populate capacitor.
A8
VDD_ANA Supply capacitor to
GND. VDD_ANA
Leave open. No need to populate capacitor.
A9 VDD_RF Supply capacitor to
GND. VDD_RF
Leave open. No need to populate capacitor.
B1
GND GND no change
B2
GND GND no change
B3 Reserved Do not connect Reserved Do not connect. no change
B4 GND GND no change
B5 GND GND no change
B6 GND GND no change
B7 V_TH V_TH no change
B8 GND GND no change
B9 VDD_USB Connect to GND if
not used VDD_USB
no change
C1 PIO8 /
EXTINT1 Pull-up resistor of
100k to VDD_IO. PIO8 / EXTINT1
Leave open.
No need to populate resistor. Input voltage levels
have changed. See
AMY-6M Data Sheet [1].
C2 Reserved Do not connect Reserved Do not connect. no change
C7
USB_DM Leave open if not
used. USB_DM Leave open if not
used. External series resistor should be changed to 22
Ohm instead of 27 Ohm if usb is used.
C8 PIO18 Leave open PIO18 Do not connect. no change
C9 PIO21 Always connect to
GND PIO21/ SPI SCK Connect to GND if
not used.
no change
D1
PIO7 /
EXTINT0 Pull-up resistor of
100k to VDD_IO. PIO7/ EXTINT0 Leave open if not
used. No need to populate resistor. Input voltage levels
have change. See
AMY-6M Data Sheet [1].
D2 Reserved Leave open Reserved Leave open. no change
D7 USB_DP Leave open if not
used. USB_DP Leave open if not
used. External series resistor should be changed to 22
Ohm instead of 27 Ohm if usb is used.
D8
V_RESET Connect to
VDD_3V. V_RESET Connect to
VDD_3V.
no change
D9 VDD_3V VDD_3V no change
E1 Reserved Leave open. Reserved Leave open. no change
E2 Reserved Leave open Reserved Leave open. no change
E8 PIO23 Always connect to
GND PIO23 Always connect to
GND.
no change
E9 VDD_B NC or supply cap VDD_B Leave open. no change
F1 TIMEPULSE Leave open if not
used. TIMEPULSE Leave open if not
used.
no change