Reset Button
To reset to factory defaults, press and hold the
Reset button for more than 10 seconds while the PowerBeam
is powered on. Alternatively, the PowerBeam may be reset
remotely via a Reset button located on the bottom of the
PoE Adapter.
Release Button
After you assemble the PowerBeam, check
the Release button; it should be fully engaged in the Release
Button Slot of the Rear Housing. This ensures that the Antenna
Feed is locked into place. If you need to remove the Antenna
Feed, you must depress the Release button first.
LEDs
Signal
In airOS®, you can modify the wireless
signal strength threshold values for each LED on
the Advanced tab under Signal LED Thresholds. The
default values are shown below:
LED will light green when the wireless signal
strength is above -65 dBm.
LED will light green when the wireless signal
strength is above -73 dBm.
LED will light amber when the wireless signal
strength is above -80 dBm.
LED will light red when the wireless signal
strength is above -94 dBm.
Ethernet
The Ethernet LED will light steady green
when an active Ethernet connection is made and
flash when there is activity.
Power
The Power LED will light green when the
device is connected to a power source.