Ubiquiti GigaBeam GBE-LR, Быстрый старт, Страница: 18 / 24

Note: Do NOT make simultaneous adjustments on the AP and Station.
2. Station Visually aim the Station at the AP. To adjust the Station’s position,
adjust the azimuth and elevation as described in step 1.
3. Open the Configuration Interface. Select Tools and then select Align Antenna.
4. Repeat steps 1-2 until you have achieved an optimal link and both the 60G and
5G LEDs are solidly lit blue. This ensures the best possible data rate between
the radios.
Note: Maximum signal strength can best be achieved by iteratively
sweeping through both azimuth and elevation.
5. Lock the alignment on both radios by tightening all the nuts.
6. Observe the signal level of each radio to ensure that the values remain
constant while tightening the nuts. If any value changes during the locking
process, loosen the nuts, finalize the alignment of each radio again, and
retighten the nuts.
Installer Compliance Responsibility
Devices must be professionally installed and it is the professional installer’s
responsibility to make sure the device is operated within local country regulatory
requirements.
GBE-LR Quick Start Guide