4
© 2021 Ubicquia, Inc.
3.3
Use a 3/16” Hex bit to unscrew
and remove the clamp adjustment
cover from the mounting clamp.
APAI:
Discard cover
AP6:
Set cover aside
to be used later.
3.4
Align the shuttles on the top of the
clamp with the rail openings on the
bottom of the UbiHub housing while
still in the box. There is a single
orientation for assembly.
3.5
Slide the clamp along the housing
rails and hand-tighten into position
for now.
NOTE:
If clamp placement was
premeasured, or if installing
multiple units on the same
luminaire type, set the clamp
position using the reference
dimensions on both the housing
and clamp, then tighten all
adjustment bolts to 40 in-lbs
torque.
3/16”
3.6
Use a 1/2” deep drive socket to
loosen the swivel locking nut and
rotate to open the clamp.
1/2”
3.7
If the luminaire pole arm is
thinner than 2” IPS, install the
appropriate clamp insert pair to
adjust the clamp size. The clamp
inserts can be used to fit either
a 1.5” IPS (Darker Set) or 1.25”
IPS (Lighter Set).
3.8
Once the appropriate insert pair is
selected, pull the red tab to remove
the protective film from the inserts,
exposing the adhesive.
1
2
1.25”
1
2
1.50”
