UAZ CARGO, Руководство по эксплуатации

Страница: 120 / 208

120
2. If the engine turns on after prolonged stop, it is recommended
to wait until the electric fuel pump is switched off (about 5 s).
3. The system functions correctly if a malfunction indicator
lamp (on the instrument cluster) switches on and off. If the mal-
function indicator lamp continues to glow, it is required to detect
and remove the malfunction (refer to “Diagnostics”).
ATTENTION! If the motor vehicle has malfunctioning sys-
tems (the malfunction indicator lamp continuously glows), it can
cause the failure of the engine converter and oxygen sensor in
exhaust gases.
4. Press the clutch pedal until stop.
5. Switch on the starter.
6. Release the key after starting the engine (turn off the starter).
Try to start the engine not earlier than 15–20 seconds after the
first attempt.
When starting the engine, it is not recommended to press the
throttle pedal.
After starting the engine, its system will automatically set the
fast idle speed to warm up the engine and gradually reduce it as
the engine warms up.
If the engine does not start after the third attempt, stop the
ignition, detect and remove the malfunction.
Starting a cold engine at temperature below -20 °C.*
In order to ease the starting of cold engine at low temperature,
preliminary warm up is required (by steam, hot air, etc.).
The following sequence of operations is the same as in case of
starting from cold at -20 °С and above.
Starting a hot engine
The sequence of operations is the same as in case of starting
from cold at -20 °С and above.
* If the motor vehicle is equipped with the starting pre-heater, it is recommended to use it
at -10 °C and below