UAV-1003599-001
25
Rev A
7.8 Post Installation Checks
7.8.1 Ground Tests
Transponder testing can be conducted to verify Mode A/C/S and Extended
Squitter operation. See tailBeaconX Instructions for Continued
Airworthiness (UAV-1003600-001) for test procedures.
7.8.2 ADS-B Out Performance Test
If the owner desires to further confirm the tailBeaconX was installed and
configured properly, perform a flight within ADS-B airspace coverage and
request a FAA flight test compliance report.
To perform an ADS-B Out flight check requires flying in airspace where
ADS-B coverage exists. In some areas in the country, you may need to be
at a higher altitude to ensure coverage. Use of a portable ADS-B In
receiver with an EFB (or equivalent) can provide the pilot an indication that
the airplane is within ADS-B coverage.
If a dedicated flight is desired, perform a take-off, climb, simple maneuvers
(standard rate turns around a point for example), descend and land.
Do
not perform any aerobatic maneuvers.
Further guidance for flight test
procedures can be found in AC 20-165B
.
Upon completion of the flight, request an ADS-B Aircraft Operation
Compliance Report (ACR) at the Public ADS-B Performance Report
Request Internet site:
https://adsbperformance.faa.gov/PAPRRequest.aspx
8 System Configuration
8.1 tailBeaconX Configuration
8.1.1 Verify Software Version
Before configuring the tailBeaconX, verify that the version of software
installed on the tailBeaconX matches the software version identified in the
table below. To do so:
•
Use the “skyBeacon Installer Application” on iOS or Android, and
navigate to the “Monitor” tab.
