RT-2087/ZPX-A User and Installation Guide
UAV-1005667-001 Rev A
ECCN 7A994
Page 15 | 48
5.9 System Limitations
Installation
This article meets the minimum performance and quality control standards
required by DoD AIMS 17-1000. If installing this article on or in a specific
type or class of aircraft, separate approval for installation is required. As an
example, for a military UAS to gain platform approval requires verification
of functionality and performance in accordance with AIMS 1102 and 1103.
5.10 Regulatory Compliance
Aircraft using ZPX-A must evaluate their needs to be compliant with 14
CFR 91.215, 91.225 and 91.227. While in transponder airspace specified in
14 CFR 91.215, ZPX-A must be maintained to 14 CFR Part 91.413.
While in ADS-B OUT airspace specified in 14 CFR 91.225, ZPX-A must be
configured and equipped to meet the requirements of 14 CFR 91.225 and
91.227.
For ZPX-A to meet the ADS-B OUT requirements of 14 CFR 91.225 and
91.227, a compliant position source must be connected. See Section 9 and
Appendix B for details on the position interface, and Appendix C for
representative compatible equipment.
To meet 14 CFR 91.225 and 91.227 with no operational limitations,
dynamic (in-flight) control is necessary. See Section 8 and Appendix A for
details on the control interface, and Appendix C for compatible equipment.
For additional guidance on ADS-B OUT installation and approval, refer to
AC 20-165B
(“Airworthiness Approval of ADS-B OUT Systems” dated 7
Dec 2015).
