45
UAV-1001006-001
ECCN 7A994
Pin 41 is shown as example for output on GPS Out 3. Pins 54, 56 or 58 can be used as alternates.
After wiring is complete configure the GNS to send ADS-B+ to Echo as follows:
Power on the GNS and press and hold the ENT key and turn the unit on. Release the ENT key
when the display activates. After the GNS has completed startup you can access the port
configuration using the right-hand knob.
Configuration pages can be accessed by ensuring the cursor is off and rotating the small right
knob.
To change data on the displayed Configuration Page, press the small right knob (CRSR) to turn
on the cursor. Rotate the large right knob to change between data fields. Rotate the small knob
to change a field that the cursor is on. Once you have made the desired selction, press the
ENT key to accept the entry.
Use the small knob to reach the MAIN RS232 CONFIG page
Select the CHNL number that matches the pin Echo is wired to example pin 41= Out 3
Select ADS-B+ for the Output Value
Press Enter
Power the GNS Off and then On
Echo Installer Application Settings:
Equipment
Setup
Source
Control
Source
GPS
Source
COM2
Rate
COM2
Protocol
GNS 4xxW-5xxW
APP
As required
COM2
9600
ADS-B+
Содержание echo
