Integrated Technical Vision Ltd.
http://www.itvsystems.com.ua
2
code identifier controller), you should use 4,7kOm resistor (supplied) installed between the
terminal and iButton "Earth" reader, as shown in Fig. 1.
When using twisted pair (STP, UTP, FTP) to connect the reader should be followed the order
of connection shown in Fig. 2.
Figure 2
Type of interfaces
The proximity reader is intended to apply in different access control systems, using RS232,
Wiegand 26, Wiegand 32, Wiegand 34, Wiegand 37, Wiegand 40, Wiegand 42 and
TouchMemory interface.
Mounting
It is recommended to mount the reader on a wall closely to a
door at appropriate height.
Do not place the reader on the metal surfaces, since it
causes decreasing of reading distance.
Reader installation
Loosen the screw at the bottom of the reader.
Remove the top cover, remove the back plate.
Mount the back plate of reader on the wall using the
fixtures provided (see fig. 1).
Prepare all wires for connection and connect them to the
reader in according to Table 1 and User Manual of the
access control panel to be utilized.
Insert the reader in the back plate (see fig. 2).
Put the top cover and tighten screw at the bottom of the
reader.
Ensure that all locking tabs are securely engaged.
The Reader Operation
The RFID Card Code Reading
The card code reading is annunciated by built-in buzzer and LED lamp according to
interface type and annunciation mode (see Section «Data transfer and Annunciation»).
Repeated reading will be available after 0.75 sec if the card is removed from the reader
sensing area.
Figure 1
Figure 2
