http://u-prox.com
21
Installation recommendations
Panel should be installed on the wall next to the door for users may easily pass card
to it. To connect the cable under the body of panel it is necessary to have a small
deepening or a hole with diameter of 14 mm.
Do not install panel on a metal surface, as it reduces the range of reading of built-in
reader.
Power cables and other cables should not be located less than 0.1 m from the panel
enclosure.
If the second reader is used, it must be at least 20 cm from panel to eliminate the
effect of double reading.
Installing Panel
Loosen the screw at the bottom of panel. Remove the upper
lid, remove the back plate. Using the back plate of the panel
as a template, mark and drill two holes at the place of a 5
mm and 30 mm (see Fig. 12). Run the cable in the central
hole, attach the back plate to the wall using the supplied
plastic anchors and screws. Connect panel to a previously
placed cable connecting it to the power supply and the
external reader. Insert panel into the back plate, put the top
cover and fix with the screw. (See Figure 13).
Fig 13.
Installing the Panel
Do not place installation cables to the right of the panel.
Figure 12
. The back plate
