PAGE 1 OF 6
1120 IH-8938
FIRE RATED STANDARD SAFE
1-800-295-5510
uline.com
H-8938
IMPORTANT! Record the serial number from the
tag on back of safe.
Keep keys and combination in a secure place,
away from children.
Do not store backup key, combination or this
document in the safe.
GETTING STARTED
1. When first receiving the safe, open door with key in
order to install batteries. Batteries are included and
are located inside the safe.
2. To open door with key, first remove lock cover from
front of faceplate using a flathead screwdriver, as
shown. Insert key and turn clockwise. Hold key in
open position and turn knob to the right to open door.
NOTE: Key has also been provided in case
security code is lost or forgotten or if batteries
run low. If key is lost, reference serial number
located on the back of the safe to get a
replacement.
3. Locate batteries inside the safe. Open battery
compartment on back of door by pushing tab to the
right. Install batteries.
ENTERING SECURITY CODE
1. After installing batteries, locate reset button on
inside of door near hinge.
2. Press reset button and release it; user will hear
a beep.
DO NOT SHUT DOOR UNTIL USER HAS
CONFIRMED NEW SECURITY CODE HAS BEEN ENTERED
CORRECTLY.
3. With door open, enter user's personal security
code, which can be three to eight digits long, and
confirm new code by pressing the lock key
on
electronic touch pad. User will have five seconds to
press the lock key
, otherwise user will have to
start over from step one. There will be two beeps (if
sound is turned on) and green light will flash twice if
code has been entered successfully. Before closing
door, enter new security code. Press the lock key
to make sure lock releases knob so that it can
turn and retract the live-action locking bolts.
4. If code fails, go through steps 1-3 again. If code
works successfully, then lock safe.
5. When opening the safe in the future, enter security
code set, followed by the lock key
, and turn
knob.
TOOLS NEEDED
HARDWARE INCLUDED
Drill
50 mm Lag Screw x 2
Washer x 2
40 mm Plastic Anchor x 2
3/8" Drill Bit
Flathead Screwdriver
10 mm Socket Wrench
USAGE
Lock Cover