PAGE 1 OF 6
0621 IH-7595
H-7595
PACKING TABLE
FILE DRAWER
1-800-295-5510
uline.com
CAUTION! Some parts may have sharp
edges. Care must be taken when handling
pieces to avoid injury. For your safety, wear
a pair of work gloves when assembling.
ATTACHING TO STEEL TOP
NOTE: Mounting channels are included with
the steel top. Channels may extend past the
drawer assembly.
1. To free drawer from housing, fully extend the drawer
from the housing. Flip one plastic tab on the sliding
rails up and the second plastic tab on the sliding
rails down. Drawer is now unlocked from housing
and can be removed. (See Figure 1)
2. Turn the packing table over. On the underside of
the table, slide mounting channels front to back
into table flanges. When channels are aligned,
mounting holes should be approximately 13½"
apart. Secure each channel with two 1/4"-20 x 5/8"
bolts. (See Figure 2)
3. Attach the drawer housing to the mounting
channels using four 1/4"-20 x 1/2" bolts.
(See Figure 2)
4. Insert the drawer and turn the packing table right
side up. Cycle the drawer in and out a few times to
check operation.
NOTE: The drawer and suspension have a
70 lb. weight capacity.
ASSEMBLY
Figure 2
Figure 1
Mounting Channels
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Tab
Drawer
TOOLS NEEDED
Flathead Screwdriver
Phillips Screwdriver
7/16" Wrench
Drill and 5/32" Drill Bit
(if attaching to wood top)
