PAGE 1 OF 3
0716 IH-5663
π
H-5663
DIGITAL SAFE
1-800-295-5510
uline.com
TOOLS NEEDED
HARDWARE INCLUDED
Drill
50mm Lag
Screw x 4
Washer x 4
40mm Plastic
Anchor x 4
3/8" Drill Bit
3/16" Drill Bit
Flathead Screwdriver
10mm Wrench
USAGE
GETTING STARTED
1. When you first receive your safe, you will need to
open the door with the key in order to install the
batteries. Batteries are included and are located
inside the safe.
2. To open the door with the key, first remove the
lock cover from the front of the faceplate using a
flathead screwdriver, as shown. Insert the key and
turn counterclockwise. Hold the key in the open
position and turn the knob to the right to open the
door.
NOTE: This key has also been provided in case
you lose or forget your security code or if the
batteries run low. If you lose the key, you'll
need to reference the serial number located
under the removable lock cover to get a
replacement.
3. Locate the batteries inside the safe. Open the
battery compartment on the back of the door by
pushing the tab in the direction of the arrow. Then,
install the batteries.
NOTE: The reset button located on the inside
of the door is covered with a removable cap.
When you use the reset button while setting
your own combination, remove the cap to
access the button. Use a pen tip to push the
reset button. Replace the cap securely over
the reset button after setting your combination.
Failure to do so will compromise the safety and
security of the safe.
ENTERING YOUR SECURITY CODE
To enter your own security code, you will need to follow
the steps listed below:
1. After installing the batteries, locate the reset button
on the back of the door.
2. Press the reset button with a pen tip and release it;
you will hear a beep.
DO NOT SHUT THE DOOR UNTIL
YOU HAVE CONFIRMED THAT YOUR NEW SECURITY
CODE HAS BEEN ENTERED CORRECTLY.
3. With the door open, enter your own personal
security code, which can be 3-8 digits long, and
confirm your new code by pressing the
key on
the electronic touch pad. You will have 3 seconds
to press the
key, otherwise you will have to start
over from step one. There will be 2 beeps (if the
sound is turned on) and the green light will flash
twice if your code has been entered successfully.
Lock Cover
