PAGE 1 OF 2
0113 IH-3630
H-3630, H-3631
H-3632, H-3633
STEEL ASSEMBLY TABLE
1-800-295-5510
uline.com
π
HARDWARE INCLUDED
•
(4) 3/8" x 3" Bolts
•
(4) 3/8" Flange nuts
STARTER TABLE
NOTE: Install all bolts and nuts prior to tightening.
1. Unfold leg assemblies. (See Figure 1)
2. Unfold flat braces and line up with holes in leg
assemblies. Install to leg using 3/8" x 3" bolts and
nuts. (See Figure 2)
ADjUSTING TABLE HEIGHT
1. Remove pre-installed leg bolt and adjust leg to
desired table height. Reinstall leg bolt and nut.
(See Figure 3)
NOTE: When adjusting to the lowest height
setting, the flat brace bolts must be removed
from the leg assemblies. Reinstall flat brace
bolts after leg bolts are inserted.
2. With the aid of a helper, turn table upright.
(See Figure 4)
3. If the table is a stand alone table, all nuts can be
tightened to 40-50 foot pounds.
NOTE: Do not tighten if add-on tables
will be attached.
For assembly of add-on tables, see page 2.
TOOLS NEEDED
9/16" Wrench (2)
ASSEMBLY INSTRUCTIONS
Figure 1
3/8 x 3" Bolts
and Nuts
Flat Brace
Figure 2
Leg bolt
Desired
Table
Height
Leg bolt
Figure 3
Figure 4
