manualshive.com logo in svg

U-Line H-3533, Инструкция по эксплуатации, Страница: 1 / 3

Поделиться
Скачать
U-Line H-3533 Скачать руководство пользователя страница 1

PAGE 1 OF 3 

0812 IH-3533

π  H-3533

KiHlberg JK35T-590  

Wide CroWn  

PneumaTiC Plier STaPler

1-800-295-5510

uline.com

OPERATION

lOAdINg ThE mAgAzINE

1.  Pull the pusher all the way back until it snaps in 

around the parking button. Feed in a staple strip  

from above into the magazine and push it forward  

by hand. (See Figure 1)

2.  Release the pusher by pressing the parking button. 

(See Figure 2)  

USINg ThE STAPlER

WARNINg! Be sure that the stapler nozzle is 

not pointed at yourself or anyone else when 

connecting it to the compressed air line. 

1.  Adjust the air pressure to the lowest one that 

will drive staples to the desired depth. Start at 

approximately 5.5 bar and raise this by 0.5 bar 

increments until the correct operating pressure for 

the job is found. 

CAUTION! Never exceed 7 bar air pressure.  
A low air pressure will reduce maintenance 
costs!

2.  This stapler has only single shot firing without safety 

yoke. 

a.  First place the stapler around the work piece.

b.  Then pull the trigger.

NOTE: during operation, the plier's gap is fixed 
but it can be set to accommodate different 
material widths by means of spacers 3 and 

6mm thick underneath the tongue. These are 

delivered with the stapler as a set of longer 
screws to be used when spacers of more than 

3mm total are inserted. 

Figure 2

Pusher

Parking

Button

Figure 1

Содержание H-3533

Страница 1: ...ressure to the lowest one that will drive staples to the desired depth Start at approximately 5 5 bar and raise this by 0 5 bar increments until the correct operating pressure for the job is found CAUTION Never exceed 7 bar air pressure A low air pressure will reduce maintenance costs 2 This stapler has only single shot firing without safety yoke a First place the stapler around the work piece b T...

Страница 2: ...r use oxygen combustible gases CO2 steam or high pressure gas tanks as power sources The stapler may explode and cause serious injury Use only dry clean pressure regulated compressed air to drive the stapler Eye protection must be worn by the operator and others in the work area Always use personal protection equipment as required such as ear protection hard hats etc Never use a defective stapler ...

Страница 3: ...ples only Magazine loading Loaded from above Firing of the stapler Single shot firing Air consumption per shot 0 85 1 at 6 bar operating pressure safety warnings CONTINUED Never point the stapler at yourself or at anyone else whether it contains staples or not Always remove your finger from the trigger when not driving staples Connect the stapler to the compressed air line before loading staples M...

Отзывы:

Нет отзывов