0213 IH-3130U
PAGE 1 OF 2
5-7 STEP SAFETY ANGLE
ROLLING LADDERS
12" DEEP TOP STEP
PARTS
ASSEMBLY
Step Ladder
Notched Bushing (4)
Handrail Bracket (2)
(shipped attached to side of stile)
Hardware Kit (1)
(misc. hardware included)
F. Back Panel (1)
E. Base Panel (1)
C. Rear Handrail Bar (1)
(shipped under a step
attached with orange ties)
9
⁄
16
" Wrench or Socket (2)
7
⁄
16
" Wrench or Socket
TOOLS NEEDED
WARNING! Assembly of these types of ladders
can be inherently dangerous. Please take all
necessary precautions during the assembly
process. Always use a separate ladder to
finish assembly in high places. Never climb a
ladder that is not completely assembled. Do
not assemble or use a ladder with missing or
damaged parts. Use proper lifting mechanics
when assembling a ladder. Watch for overhead
electrical hazards and obstructions.
STEP 1: FRAME ASSEMBLY
NOTE: DO NOT tighten bolts until instructed to.
NOTE: Back panel (F) has both round and
slotted holes. The round holes are at the bottom,
and the slotted holes are at the top.
1. Place the ladder stile (D) on the floor. Be sure to
assemble on a protective surface so the finish does
not get damaged. (See Figure 1)
Rubber Mallet
Safety Glasses
A. Handrail (1)
B. Handrail (1) Opposite
D. Stile (1)
H-3130U, H-3131U
H-3132U
1-800-295-5510
uline.com
π
