PAGE 2 OF 20
0122 IH-1036
INSTALL WATER RESERVOIR
Before using the dispenser: Wash the moistening brush
with soap and water. Rinse thoroughly.
1. Insert the brush in the water reservoir. (See Figure 1)
Figure 1
2. Switch power on.
NOTE: Make sure top heater is switched off and
no tape is loaded.
3. While holding down the green Random Length
button, take the reservoir in your left hand and insert
the pivot shaft into the slots on sides of dispenser.
Move shaft up to the top of the slots. (See Figure 2)
Figure 2
Reservoir
Random
Length
Button
Pivot Shaft
Slots
4. Slide reservoir down so bottom fits over tab
on dispenser.
5. Release the green button.
INSTALL BRACKETS FOR WATER BOTTLE
1. Mount the bottle brackets on left side of machine,
inserting first the upper tooth in top slot then the
lower slot until it locks. (See Figure 3)
Figure 3
Top Slot
Bottle
Bracket
Lower Slot
FILL WATER BOTTLE
1. Remove bottle from brackets and turn over so filler
opening faces up. (See Figure 4)
Figure 4
WATER
SETUP
