PHONE 1-800-295-5510
FAX 1-800-295-5571
WEB uline.com
Loading the Tool
1. Pull the Pusher back until it stops on pusher pivots. Rotate pusher to position.
2. Insert up to 2 sticks of appropriate staples into the magazine. Let the sticks slide
forward to the front of the magazine.
3. Pull the pusher back to an upright position and gently let the pusher slide forward
against the staples. Do not let the pusher slide forward and strike the staples at
high speed as this may deform the staples and damage the tool.
Staple Leg Length
1. Loosen the set screw with a 3mm Allen wrench.
2. Turn adjusting rod 180
°
with a screw driver to the desired setting.
3. If you are using ¾” staples set L up.
4. If you are using 5/8” staples set S up. (diagram)
5. Tighten the set screw.
CHICAGO
•
MINNEAPOLIS
•
LOS ANGELES
•
NYC/PHILA
•
ATLANTA
•
DALLAS
