u-blox ZED-F9P Interface Description - Manual
Advance Information
CFG-RST continued
Byte Offset
Number
Format
Scaling
Name
Unit
Description
2
U1
-
resetMode
-
Reset Type
0x00 - Hardware reset (Watchdog) immediately
0x01 - Controlled Software reset
0x02 - Controlled Software reset (GNSS only)
0x04 - Hardware reset (Watchdog) after
shutdown
0x08 - Controlled GNSS stop
0x09 - Controlled GNSS start
3
U1
-
reserved1
-
Bitfield navBbrMask
This graphic explains the bits of
navBbrMask
Name
Description
eph
Ephemeris
alm
Almanac
health
Health
klob
Klobuchar parameters
pos
Position
clkd
Clock Drift
osc
Oscillator Parameter
utc
UTC Corr GPS Leap Seconds Parameters
rtc
RTC
aop
Autonomous Orbit Parameters
5.9.22 UBX-CFG-TMODE3 (0x06 0x71)
5.9.22.1 Time Mode Settings 3
Message
UBX-CFG-TMODE3
Description
Time Mode Settings 3
Firmware
Supported on:
•
u-blox 9 with protocol version 27
(
only with High Precision GNSS products
)
Type
Get/Set
Comment
This message is deprecated in protocol versions greater than 23.01. Use
,
instead.
See the
Legacy UBX Message Fields Reference
for the corresponding configuration item.
Configures the receiver to be in Time Mode. The position referred to in this message is that
of the Antenna Reference Point (ARP).
Header
Class
ID
Length (Bytes)
Payload
Checksum
UBX-18010854 - R04
Advance Information
Page 77 of 259