u-blox XPLR-AOA-3, Руководство пользователя

Страница: 10 / 44

UBX-22006906 - R03 Page 10 of 44
C1-Public
Figure 6: Updating the software on the board using s-center
3.1.3 Flashing from the Command line
Use the following procedure to flash the board over the UART connection.
1.
Download the u-connectLocate software container from the u-connectLocate product page [4].
2. Boot the board into Software Update mode by connecting the SWITCH_2 pin to ground while
powering up the board.
3. Flash the u-connectLocate software using the bundled (Windows only)
newtmgr
executable.
Alternatively, use the Newt Manager Guide [6] to install the
newtmgr
application tool for MAC OS,
Linux, and Windows.
4. Use Newt Manager to install u-connectLocate on the NINA-B411 module:
newtmgr --conntype=serial --connstring="COMXX,baud=115200" image upload <binary
image>
5. Press the reset button to reset the application board or reset it with
newtmgr
:
newtmgr --conntype=serial --connstring="COMXX,baud=115200" reset