u-blox NORA-W30 Series, Руководство по системной интеграции

Страница: 40 / 52

NORA-W30 series - System integration manual
UBX-22021119 - R02 Regulatory compliance Page 40 of 52
C1-Public
ISED end product labeling
The end product shall bear the following statement in both English and French in a conspicuous
location on the device:
Labels of end products capable of operating within the band 5150 – 5250 MHz shall also include:
For indoor use only
Pour usage intérieur seulement
When the device is so small or for such use that it is not practicable to place the statements above on
it, the information shall be placed in a prominent location in the instruction manual or pamphlet
supplied to the user or, alternatively, shall be placed on the container in which the device is marketed.
However, the FCC/ISED ID label must be displayed on the device as described above.
In cases where the final product will be installed in locations where the end-consumer is unable to see
the FCC/ISED ID and/or this statement, the FCC/ISED ID and the statement shall also be included in
the end-product manual.
6.3 European Union regulatory compliance (pending)
6.3.1 Safety standard
In order to fulfill the safety standard EN 62368-1 [10] , the NORA-W30 module must be supplied with
a Class-2 Limited Power Source.
6.3.2 ETSI Equipment classes
In accordance with Article 1 of Commission Decision 2000/299/EC 10 , NORA-W30 is defined as either
Class-1 or Class-2 radio equipment, the end-product integrating NORA-W30 inherits the equipment
class of the module.
☞
Guidance on end product marking, according to the RED can be found at: http://ec.europa.eu/
☞
The restrictions while operating the NORA-W30 in Wi-Fi mode in the European countries are
shown in section “European Union regulatory compliance” of the NORA-W30 data sheet [2] .
10
2000/299/EC: Commission Decision of 6 April 2000 establishing the initial classification of radio equipment and
telecommunications terminal equipment and associated identifiers.
Contains transmitter module IC: 8595A-NORAW3
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence -exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.
Contient le module émetteur IC: 8595A-NORAW3
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes:
1.
L' appareil ne doit pas produire de brouillage;
2. L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre lefonctionnement.