1. Overview
2. Setup
1. Download and install the EVK-M8QSAM / EVKM8xCAM
software (and documentation) from
www.u-blox.com/evk-search.
See installation notes on the back of this card.
2. Connect the unit to a PC. Options:
• USB: Connect via USB port (
A
). Set switch (
B
) to
USB. The USB driver installs automatically when
the device is connected to a PC; this requires an
internet connection.
• UART: Connect via RS232 (
C
). Set switch (
B
) to
RS232.
NOTE
: Press RST (
D
) after setting switch (
B
).
3. Provide power to the device at all times, either via USB
on the back or the V5 IN pin on the front (
F
).
4. EVK-M8QSAM: Place the EVK with an unobstructed
view of the sky, no external antenna connectivity at (
E
).
5. EVK-M8QCAM / EVK-M8CCAM: Place the EVK with
an unobstructed view of the sky or connect antenna
signal to (
E
).
6. Start the u-center GNSS evaluation software and se-
lect the corresponding COM port and baud rate.
Quick Start EVK-M8QSAM / M8xCAM
Copyright © 2018, u-blox AG
A (USB)
C (RS232)
UBX-16024579 - R03
D (RST)
B (USB/RS232 switch)
E (RF IN)
EVK-M8xCAM only
F (14-pin connector)
G (Boot)
