50
ON:Enable Frequency Reverse
OFF:Disable Frequency Reverse
3. Press number keys to confirm and exit.
NOTE: This function can be temporarily used in Channel mode . Once the radio is turned
off or switched to another channel, the temporary setting will be erased and back to initial
settings.
TOT (Time-out timer)
The time-out timer limits the amount of transmitting time. When you reach the time limit
which has been programmed by your dealer, your transmission will be cut off. In order to
transmit again, you must release PTT button to reset the timer.
1. In standby,press
,then press ìLCD displays "TOT-X".
2. Press [
/
] to select the desired value.
3. Press number keys to confirm and exit.
CTCSS/DCS Encode and Decode
1. In standby,press ,then press to enter into CTCSS/DCS Encode and Decode.
2. Repeat above operation to set as below:
LCD displays T icon,it indicates CTCSS encode set in current channel.
LCD displays T and SQ icon,it indicates CTCSS encode and decode set in current channel.
LCD displays DCS icon,it indicates DCS encode and decode set in current channel.
3. In corresponding icon,press [
/ ] to select the desired CTCSS/DCS encode
and decode.
UP
DOWN
UP
DOWN
51
4. Press
*
or to confirm and exit.
NOTE:This function can be temporarily used in Channel mode. Once the radio is turned off
or switched to another channel, the temporary setting will be erased and back to initial
settings.
Talk Around
By Talk Around function,you can directly communicate with other radios in your group
in case the repeater is not activated or when you are out of the repeater range. The transceiver
will transmit by RX frequency with its CTCSS/DCS signaling.
1. In standby,press
,then press key,LCD displays "TALK--OF".
2. Press [
/
] to select the desired setting .
ON:Enable Talk Around
OFF:Disable Talk Around
3. Press number keys to confirm and exit.
NOTE: This function can be temporarily used in Channel mode . Once the radio is turned
off or switched to another channel, the temporary setting will be erased and back to initial
settings.
Voice Prompt
The prompting tone provides confirmation of entry, error status or malfunctions of the
transceiver. You can enable or disable this function.
1. In standby,press
,then press ,LCD displays "BEEP--XX".
2. Press [
/
] to turn on/off BEEP voice prompt.
P
3
UP
DOWN
UP
DOWN
